Exhibits

Whether you are looking for solutions for single processes or subprocesses, or
wish to reproduce the entire process chain from raw part to finished part—at
the CIMT 2019, the EMAG Group offers you a comprehensive overview of their
full bandwidth of technologies and manufacturing solutions.

VT 4 / VT 200

Short cycle times, high precision and safe processes are what distinguish shaft machining on VT series turning centers. In these turning centers, traditional horizontal machining has literally been put on its head.

More about VT 4 / VT 200

VM 9

With the new VM 9 vertical turning center, EMAG has introduced a platform that covers a broad spectrum of applications thanks to the combined turning, milling and drilling technologies and intelligent machine design. The highly accessible machining area and workpiece spindle fitted at the bottom ensure short tooling times and maximum flexibility in the production of large components.

More about VM 9

VL 200 GT

The combination of hard pre-turning and finish grinding reduces machining time. The VL 200 GT uses various machining technologies to minimize machining times. Combined processes shortens process chain.

HLC 150 H

The HLC 150 H is a gear hobbing and worm milling machine with outstanding versatility and flexibility. This high-performance gear machining center caters to a very wide workpiece range: From gears and pinions for gearboxes over armature shafts and worms up to transmission shafts with total length of up to 500 mm (20 in).

More about HLC 150 H

ELC 160 HP

The ELC 160 HP was designed for the laser welding of the control gear and clutch. This manufacturing system combines several process steps into one perfectly timed system.
Joining (press fitting), induction pre-heating (if required by the material) and connecting the components with laser welding.

More about ELC 160 HP